formlabs Fuse 1, Руководство пользователя

Страница: 46 / 64

44
To clean the camera lens:
1. Open the print enclosure door.
2. Loosen the thumb screw in the front-center of the ceiling of the print enclosure. The cassette
tray swings down.
3. Slide the optical cassette out of the cassette tray.
4. Return the cassette tray to its closed position without an optical cassette. This provides
easier access to the camera lens.
5. Tighten the thumb screw until it fully engages to lock the cassette tray in place.
6. Using the provided telescoping mirror, visually locate
the camera lens.
7. Wet a polyester cloth swab with a small amount
of ethanol. The swab should not be saturated or
dripping ethanol.
8. Wipe the camera lens using the tip of the swab.
9. Wait for the ethanol to evaporate, then visually verify
that the lens is clean and clear of streaks or debris.
10. Loosen the thumb screw in the front-center of the ceiling
of the print enclosure. The cassette tray swings down.
11. Return a clean optical cassette to the window tray.
12. Return the cassette tray to its closed position. Tighten the thumb screw until it fully engages.
13. Close the print enclosure door. Press firmly to ensure that the door is fully latched. If necessary,
squeeze the door shut using the cutout on the right side of the printer for leverage.
6.4.2 Cleaning the IR sensor housing
The IR sensor housing should be cleaned after
every five prints. The printer displays a prompt on its
touchscreen to notify you if cleaning is needed.
Required supplies:
• Ethanol
• Non-reactive nitrile gloves
• Polyester cloth swabs
• Telescoping mirror
To clean the IR sensor housing:
1. Put on a new, clean pair of nitrile gloves.
2. Open the IR sensor access door, located on the top
of the printer, next to the hopper.
3. Drag the Open Door slider on the touchscreen. The
print enclosure door unlocks.
4. Open the print enclosure door.
5. Locate the IR sensor cone from below using the
telescoping mirror.
6. Remove the IR sensor by picking up the cap and
pulling the IR sensor off of its mount. Disconnect the
cable from the IR sensor.