formlabs Fuse 1, Руководство пользователя

Страница: 33 / 64

Preparation and setup | 31
4. Lower the front of the machine so that the machine sits flat.
5. Stand on one side of the printer and route your arms through the lifting straps. There are
three positions in the straps to route your arms through, depending on your stickers on
the side of the machine. Have your partner do the same on the other side of the printer.
6. Lift the machine onto the pallet using the lifting straps, lowering the printer’s feet into the
proper cutouts in the platform. Each person should push at an upward angle when lifting
to keep the printer steady and level.
The Fuse 1 is a heavy object. Use appropriate precautions and correct lifting form
when moving the machine.
7. Tilt the machine backwards and remove lifting straps. Lower the front of the printer back
onto the pallet.
8. Lower the protective bag over the top of the machine. The bag should be flush with the
sides of the machine. Tuck any excess bag material between the platform and the bottom
of the machine.
9. Place the protective pad (5) on top of the
printer. The cutout in the protective pad fits
around the hopper lid.
10. Loop two nylon binding straps
(commercially available) through the pallet
and vertically around the printer. Loop the
straps through the small holes in the pallet
underneath the platform.
11. Crimp the binding straps on the protective
pad to protect the printer from scratches.
The printer should be rigidly attached to
the pallet.
12. Encase the machine with the inner C-fold segment (2), leaving the hopper side open.
Orient the C-fold such that the foam runs horizontally and is closer to the top of the C-fold
than the bottom.
13. Encase the machine with the outer C-fold segment (3) from the hopper side, such that all
four sides of the machine are now covered. The foam on the outer C-fold fits underneath
the hopper. The C-fold should be flush with the lip of the pallet on all four sides.
14. Place the topper (4) on top of the C-folds. The cutout in the foam aligns with the
printer’s hopper.
15. Wrap a nylon binding strap horizontally around the C-folds. Position the strap one-third of
the way up from the bottom of the C-fold (approximately 50–70 cm/20–28 in). Tighten and
crimp the strap.
16. Loop two nylon binding straps vertically around the machine, passing them through the
pallet using the four small holes in the sides of the pallet. Tighten and crimp the straps.
CAUTION