Formica Group Technical Guide
| 8
FTB-0918 | Rev 2 | 6/20
TECHINCAL GUIDE USE & CARE, WARRANTY, AND INSTALLATON GUIDE
INTENTEK
™
WIRELESS CHARGING SURFACE
CAUTION:
When measuring, do not use any tools that could
damage the contact pad.
NOTE:
The end with the double layer of contact pads is where the
electronics blower oulet will be.
3. PRODUCTION: CNC OPERATIONS (TYPICAL STEPS)
3A) RESET CNC:
Reset CNC program for cutting to do a perimeter
cut of the deepest part of cavity (the part where the contact pads are
exposed). We do not recommend removal of material within this area
until after CNC operation is complete.
3B) POSITION BOARD:
Position the decorative laminate side of
panel face down on the CNC table.
3C) ALIGN BOARD:
Position the decorative laminate side of Align
reference edge of panel decorative laminate sheet to the CNC
alignment pins on the vacuum table prior to initiating the cutting
operation.
3D) WARNING:
Machining must not contact the charging zone area
contact pads which will impact/defeat the performance of the end
product.
3E) RUN CNC:
Run CNC program to make all cuts into the
substrate, which may include:
a. the electronics cavity or cavities into the substrate
b. wire or adapter tracks
c. attachment holes for table legs
3F) REMOVE CAVITY PIECE:
When job is complete, remove cavity
substrate piece (that was created with the perimeter cut) from the
cavity to reveal the contact pads. At this time, the 5"x5" masking
should also be removed.
3G) CONFIRM CAVITY MEASUREMENT:
Check to confirm the
distance from the flange where the heat sink will eventually be
screwed in to the bottom of the cavity where the contact pads are.
This measurement should be 13.31 mm. (.524 inch)
This end is where
blower outlet will
be orientented
This is where the center
point is measured