Formax FD 3300, Руководство по эксплуатации

Страница: 96 / 100

90
Chapter 5 Trouble Guide
Condition Cause Solution
Folding misalignment
along the vertical length
of the paper occurs.
Processing speed was changed midway
through operation.
Adjust the folding stopper positions of the
folding plates 1 and 2. (p.44)
Paper type (quality, thickness) was
changed midway through operation.
The folding plate was removed when
[Stopper Fixed] was set to on.
Press the key, holding down the
key.
Folding misalignment
along the sides of the
paper occurs.
Too many sheets of paper are stacked. Reduce the paper amount.
The paper feed guides are not set properly. Set the paper feed guides properly. (p.31)
The fixing screws of the paper feed guides
got loose and the paper feed guide slipped
out of position.
Tighten the fixing screws of the paper feed
guides
. (p.30)
Paper is not cut properly. Correct the folding misalignment along the
sides of the paper using the skew correction
knob. (p.42)
Continuous-feeding
occurs with small paper.
Paper out of specifications is used. Do not use paper outside the specifications.
(p.26)
The paper feed guides are not set properly. Set the paper feed guides properly.
(p.31)
Paper is not properly aligned. Stack the paper in alignment. (p.27)
Thin flimsy paper is used. Lower the processing speed.
(p.37)
Paper size with limitations in processing
speed is used.
Paper feed interval timing is too fast.
Set [Feed Interval] to [Slow].
(p.63)
The pickup air volume is too large. Set the [Pickup Air] volume according to the
paper type. (p.35)
Single-folded thick paper
jams at the folding rollers.
Paper out of specifications is used. Do not use paper outside the specifications.
(p.26)
The processing speed is too slow. Increase the processing speed.
(p.37)
Paper is not separated well. Separate the paper well. (p.27)
When large paper is
stacked on the paper feed
tray, the tray does not rise
even when the
key is
pressed.
Too many sheets of paper are stacked. Reduce the paper amount.
Heavy paper is used.
Mis-detection of double-
feed occurs.
Test folding is not carried out after the
paper is re-stacked.
Perform test folding whenever new sheets
of paper are re-stacked. (p.37)
Repeat test folding when a miss-feed or
double-feed error occurs.
Paper thickness in the double-feed
detection setting is not appropriately set.
Check the paper thickness, change the
setting of paper thickness to [Thick] and test
fold again. (p.61)
The printing state is variable within the
range of double-feed detection.
Set the ultrasonic sensor in the [D-Feed]
setting to off.
(p.61)
Mis-detection of mis-feed
occurs.
Paper is fed askew. Align paper appropriately and stack the
paper at a proper position. (p.27)
Although double-feed detection is set to
on, the paper thickness is not appropriate.
Check the paper thickness, and set
[Thickness] to [Thin] and test fold again.
(p.61)