32
Chapter 2 Basic Operation
6
Set the plate unit onto the auxiliary
paper feed tray.
Be sure to set the plate unit so that it does not
extend beyond the rear end of paper.
7
Attach the side guide unit on each side
of paper.
Side guide unit
Paper feed guide
•
Attach the side guide unit leaving some
clearance between the side guide unit
and paper. However, if the side guide
unit is set leaving too much clearance
between the side guide and paper,
accuracy of feeding may be lowered,
and folding misalignment may be apt to
occur. If the side guide unit is set striking
at the paper, double-feed or mis-feed
may be caused.
•
Make sure to leave space between the
paper feed guide and the side guide unit
as shown in the right figure.
Automatic rise/descent of the paper feed tray
• When paper is stacked on the paper feed tray, the paper feed guides are set, and the
key or
key is
pressed, the paper feed tray rises automatically.
When using large or heavy paper, the paper feed tray may become over stacked and may not be
able to rise due to paper weight. In such cases, stack less paper.
• The paper feed tray descends automatically when paper is removed from the paper feed tray. It will also
descends automatically when paper runs out on the paper feed tray during a folding operation.
• When [Detection] is turned off, the paper stacked on the tray is not detected. Therefore, when the
operation stops, the paper feed tray goes down automatically even if paper is stacked on the tray.
