Ford ENDURA 2017, Руководство пользователя

Страница: 181 / 364

System Warnings
If you accidently exceed the set speed, the
set speed indicator in the information
display will flash and you will hear an
audible warning chime.
If you intentionally exceed the set speed,
only the set speed indicator in the
information display will flash.
Using the Intelligent Speed Limiter
(If Equipped)
WARNING
The system is designed to aid the
driver. It is not intended to replace
your attention and judgment. You are
still responsible to drive with due care and
attention.
Note: When driving between countries that
use different units of measure (miles per
hour or kilometers per hour), there may be
a delay before the system changes between
speed limit units. During this time, the
display screen for the speed limiter may
differ from the actual posted speed limit.
For the best performance, make sure the SD
card is in the navigation media port.
The system allows you to automatically
limit your vehicle speed to the speed limit
that is detected by the Traffic Sign
Recognition system.
You can change the speed limiter mode
between manual and intelligent in the
information display. See
General
Information (page 76).
You can select a permanent set speed
tolerance that is in addition to the detected
speed limit through the tolerance menu in
the information display. See
General
Information (page 76).
Switching the System On and Off
Press LIM to set the limiter in standby
mode. The information display will prompt
you to set a speed or show the detected
speed limit as the set speed. The Intelligent
Speed Limiter will not limit the vehicle
speed in standby mode. The “Auto LIM”
symbol and set speed indication are greyed
out in standby mode. Press LIM again to
turn the system OFF.
Setting the Speed Limit
• Press RES with the limiter in standby
mode to set the limiter to the detected
speed limit. Speed limitation is now
activated. The Auto LIM symbol shows
as green.
• Press SET+ or SET- with the limiter in
standby mode to set the limiter to the
current vehicle speed. Speed limitation
is now activated. The Auto LIM symbol
shows as green.
• Press SET+ or SET- to gradually
change the current set speed to your
desired speed limit. The speed is
displayed in the information display
and stored as the set speed.
• Press CNCL to cancel the limiter and
place it in standby mode. The Auto LIM
symbol in the information display
shows as grey.
• Press RES to resume the limiter. The
Auto LIM symbol in the information
display shows as green.
• The limit speed will automatically
adapt to the speed limit detected by
the Traffic Sign Recognition system.
The Intelligent Speed Limiter will not
react to speed limits shown with a
supplementary sign by the Traffic Sign
Recognition system. If there is no speed
limit information available, the limiter
will switch into standby mode.
178
Endura (CDQ) New Zealand, enNZL, Edition date: 201712, First Printing
Driving Aids