Ford ENDURA 2017, Руководство пользователя

Страница: 18 / 364

SELECTING A CHILD
RESTRAINT SYSTEM
To provide protection, a child restraint
system should meet three requirements.
1. The child restraint system complies
with Australian Standard AS1754.
Infants and children must be properly
restrained at all times in an approved
child restraint which conforms to
Australian Standards AS1754 - 2004
or later. Look for the Australian
Standard Approval Mark on the child
restraint.
2. The child restraint must be suitable
for the size and weight of the child
and must be properly fitted and
adjusted.
Use the child restraint
exactly as shown in the instructions
provided with the child restraint. If you
have any doubts, contact the child
restraint manufacturer or consult an
approved Restraint Fitting Station.
3. The child restraint system should
fit the vehicle seating position (or
positions) where it will be used.
Due
to variations in the design of child
restraint systems, vehicle seats and
seatbelts, all child restraint systems
may not fit all seating positions. Before
purchasing a child restraint system, it
is recommended that the child restraint
system is tested in the specific vehicle
seating position (or positions) where
it is intended to be used. If a previously
purchased child restraint does not fit,
you may need to purchase a different
one that will fit.
INSTALLING CHILD
RESTRAINTS
WARNINGS
NEVER use a rearward facing child
restraint on a seat protected by an
ACTIVE AIRBAG in front of it, DEATH
or SERIOUS INJURY to the CHILD can
occur.
Incorrectly fitted child restraints may
swing, tip or come away causing
death or injury.
Do not use a child restraint if the
tether strap falls into a split in the
vehicle seat back or falls off the edge
of the vehicle seat.
After installing a child restraint, push and
pull it forward and back and from side to
side to verify that it is secure.
Be sure to read and follow the instructions
provided by the child restraint
manufacturer. If you have any doubts,
contact the child restraint manufacturer
or consult an approved Restraint Fitting
Station. Your automobile club or local
vehicle registration authority can provide
location details of fitting stations.
When installing the child restraint
attaching clip to the anchor fitting, raise
the head restraint (where fitted) and pass
the tether strap between the head restraint
supports. This prevents the tether strap
from falling off the outermost edge of the
seating positions.
15
Endura (CDQ) New Zealand, enNZL, Edition date: 201712, First Printing
Child Safety