Force SPARC/CPCI-520G, Техническое справочное руководство, Страница: 62 / 134

OpenBoot Firmware Base-520(G) Installation
Page 48 SPARC/CPCI-52x(G)
All SCSI buses To check all the SCSI buses installed in the system enter the following
(The actual response depends on the devices on the SCSI buses).:
Note: The command probe-scsi-all can last up to 2 minutes
without terminal message.
Single device To test a single installed device enter:
This executes the
self-test
device method of the specified device
node.
device-specifier
may be a device path name or a device alias as
described in Table 20, “Device alias definitions,” on page 45. The re-
sponse depends on the self-test of the device node.
Group of devices To test a group of installed devices enter:
All devices below the root node of the device tree are tested. The re-
sponse depends on the devices having a self-test routine. If a device spec-
ifier option is supplied at the command line, all devices below the
specified device tree node are tested.
Clock To test the clock function enter:
ok probe-scsi-all
/pci@1f,0/scsi@2
Target 6
Unit 0 Disk Removable Read Only Device SONY CD-ROM CDU-8012 3.1a
/pci@1f/pci@4,1/scsi@2
Target 3
Unit 0 Disk FUJITSU M2952ESP SUN2.1G2545
ok
ok test device-specifier
ok test-all
ok watch-clock
Watching the ‘seconds’ register of the real time clock
chip.
It should be ‘ticking’ once a second.
Type any key to stop.
22
ok