223
29. Editor Control (Option)
The switcher can be controlled from an editor. See section 29-1."Editor Control Settings" for
controlling the editor and section 29-2 "Connection Settings with Editor (EDITOR port setting)" for
editor connection.
The HVS-39ED software option is required for editor control.
29-1. Editor Control Settings
(1) Open the [SETUP - EXT I/F - EDITOR] menu.
SETUP :>
EDITOR
>TSL TLY >VTR >ROUTER
EXT I/F :>AUD XPT >AUX UNIT
(2) Select a protocol at
TYPE
between DVS(SONY DVS/BVS series compatible) and GVG-K/Z.
(3) Set
ENABLE
to ON to enable the editor control. (The Editor Control On/Off function can be
assigned to a USER button. See section 0. "USER Button.")
FUNCTION: TYPE :ENABLE :SELECT : WIPE : 1/2
EDITOR :=DVS : =ON : =ME : =NORML:
(4) If DVS is used, the bus to be controlled from the editor must be specified. Refer to the table
below to set the bus under
SELECT
. If PREV, PREV ON or ALL is set, AUX1 will be the edit
preview bus and with crosspoint number is 35. Set your editor accordingly.
Setting
Description
ME
Controls the M/E bus when
ENABLE
is ON.
PREV
Controls the preview bus when
ENABLE
is ON.
ALL
Controls both M/E bus and preview bus when
ENABLE
is ON.
ME ON
Always controls the M/E bus regardless of
ENABLE
setting.
Controls both M/E bus and preview bus when
ENABLE
is ON.
PREV ON
Always controls the preview bus regardless of
ENABLE
setting.
Controls both M/E bus and preview bus when
ENABLE
is ON.
(5) If G-K/Z (GVG protocol) is used, select the pattern control mode between two below at
WIPE
.
Setting
Description
NORMAL
Same wipe pattern numbers (0-99) as in the switcher are used in the editor.
(default setting)
LIST
Ten wipe patterns saved to Direct Pattern memory are used in the editor as
Direct Pattern Nos. 90-99. (GVG-Protocol only)
(6) Press the page down button to go to PAGE2.
FUNCTION:XPT CTL:WIP CTL:KEY CTL: : 2/2
EDITOR : =INPUT: =ON : =ON : :
