FOR-A HVS-1000EOU, Руководство по эксплуатации

Страница: 98 / 204

86
11-2. Bus Key Setup
The bus key uses separate signals for the key insert and key source. To create a bus key, select
the key insert/key source signals in each keyer menu. However, since the operation for selecting
the signal from the menu takes some time, in the HVS-1000EOU, the settings are first made at
the menu, and then the key link function is set to ON so that keys can be created by selecting
only key fill (insert) signals.
When the key link function is set to ON, the key source signal making a pair is automatically
chosen once the key insert signal is selected. To change the paired source signal, first set the
key insert signal, then change a key source for that insert signal in each keyer menu. The key
link ON/OFF setting can be made in the SETUP - MU MODE menu. (Factory default setting is
ON). This section shows an example of using the key link to create a DSK bus key.
Creating key links
The following procedure shows how to make the key pairs shown in the table below using the
DSK menu.
Key pair
１
Key pair 2
Signal name Bus button Signal name Bus button
Key source IN01 1 IN03 3
Key insert IN02 2 MATT1 4
Input signals above are assumed to be already assigned to the bus buttons. For details on
assigning signals to the bus buttons, see section 5-3-3 “Bus Signal Assignment and Inhibit
Settings.”
In the menu select section, press DSK(MASK) button to ON (lit) to display the DSK menu.
Turn F1 to select KEY SOURCE1 line.
In the KEY SOURCE1 line turn F2 to select BUS for TYPE.
Turn F1 to select KEY INSERT line. In the KEY INSERT line turn F2 to select BUS for TYPE.
Then turn F3 to select IN01 for INPUT. Turn F1 to go back to the KEY SOURCE1 line, in the
KEY SOURCE1 line, turn F3 to select IN02 for INPUT.
In the same way as above, in the KEY INSERT line, select IN03 for the INPUT and in the KEY
SOURCE1 line, select MATT1 for INPUT.
IMPORTANT
Once key pairs are set in the KEY1, KEY2, or DSK menu, other keyers can still use the
same key pair. The key pair settings can be made regardless of ON/OFF of the key
link function.
Setting KEY LINK to ON
The key link function is set to ON at the factory default, however, if it set to OFF, follow the
procedure below to set the function to ON.
In the menu select section, press the SHIFT button to ON (lit). Then press the
STATUS(SETUP) button to display the SETUP top menu.
Turn the F1 control to select MU MODE, and then press F1 or the DOWN button to open the
SETUP-MU MODE menu.
In the SETUP-MU MODE menu, turn F1 to select KEYER line. In the KEYER line, turn F2 to
set the LINK item to ON. Press ENTER on the keypad to confirm the setting.