Fondital Gazelle EVO 3000, Инструкции по установке, использованию и обслуживанию

Страница: 8 / 52

8
2.2 Equipment operation
2.2.1 Equipment start-up
Open the gas tap.
Make sure that the equipment is connected to the power mains.
OFF is displayed.
Press key to switch equipment on in manual mode: switch-on is
indicated by 2 “beeps” and the display shows:
- equipment model at bottom right: 3000, 5000 or 7000
- a hand indicating manual mode at top left
- two central digits indicating the set temperature level
- the sun indicating that equipment is in comfort mode
In manual mode, the equipment stays always on until the set temperature level is achieved.
When there is a request for burner ignition, the flashing symbol is displayed.
When the burner is on, the symbol is steady on.
When the burner is on at maximum power, the symbol is displayed.
The second flame blinks when toggling between operation at minimum power and operation at
maximum power.
To set desired temperature, see par.
2.2.3. Temperature setting
.
To set equipment operation to automatic mode, see par. 2.2.4. Automatic operation .
WARNING
If the equipment is started after a long period of inactivity, especially for models running on propane, it is possible to
experience an initial hard starting.
This means that the equipment could shut down once or a few times and make it necessary for you to reset it through key
: if display shows E99, please read paragraph 7. TROUBLESHOOTING .
2.2.2 Equipment shutdown
The equipment shuts down automatically if a malfunction occurs.
Shutdown is indicated visually by flashing message E## (where ## indicates the error code) and
acoustically by a sequence of 3 “beeps” with a 10 second gap, throughout the time of equipment
shutdown.
If shutdown can be reset by the user, the display will also show RESET flashing message.
In case of equipment shutdown, please read paragraph 7. TROUBLESHOOTING .
WARNING
The user must strictly comply with the relevant instructions (see column “For the user” of the table in paragraph 7.
TROUBLESHOOTING).
The user must NOT follow the instructions from the column “Only for qualified staff”.
3000
3000
3000