494
e23_dv55_7e.fm
[494/518]
App
en
d
ix/Extern
al D
evices
/T
ro
ub
le
sho
o
ting
[No more space Overwrite?]
Appears when screen memo memory is full. Select [Yes] and
select a screen memo to overwrite. Proceed to the save
confirmation screen. Select [No] and the site or Internet web page
reappears.
[No requested software]
Appears when attempting to start a non-existent i-
a
ppli software
from i-mode mail or Ir exchange function.
n
P. 245
(During iC transmission) [No response]
Appears when the other party could not be recognized.
[No response (408)]
Transmission disconnected due to no reply from the site or
Internet web page. Try again later.
n
P. 170
[Not enough space. Continue to overwrite?]
Appears when the screen memo is larger than the available
memory space. Select [Yes] and select a screen memo to
overwrite. The screen memo is deleted upon selection. Select [No]
and the site or Internet web page reappears.
[Omakase Lock activated]
Appears when Omakase Lock is set.
n
P. 133
[Other functions running. Unable to activate]
Software could not be updated at the set time because other
functions are running. Update immediately or set another date and
time.
n
P. 504
[Out of Digital TV service area. Unable to record]
Appears when the FOMA terminal is in a place where broadcast
waves cannot be received. Move to a location where
c
appears
to use.
n
P. 287
[Out of service area]
Appears when making a Videophone call or network service such
as i-mode, etc. is attempted but handset is outside the service
area or in a place with no signal.
Retry after moving to a location where
]
appears.
n
P. 34
[Page is not found (404)]
Specified site or Internet web page was not found. Site or Internet
web page may not exist.
[Password is not correct (401)]
Appears when authentication is not possible on the authentication
screen.
[Phone/Terminal and UIM ID will be sent]
May appear while viewing sites or Internet web pages. Select [Yes]
to send “Terminal ID and UIM ID”. To abandon sending and return
to the previous screen, select [Return] or press
c
.
n
P. 171
“Terminal ID and UIM ID” are used by the IP (Information Provider)
to identify the handset and offer customized information to each
customer, and also determine what contents offered by the IP are
available for each handset.
“Terminal ID and UIM ID” are sent to the IP (Information Provider)
using the Internet so a third party may obtain it. However,
customer’s phone number, postal address, age and sex are not
sent to the IP in this operation.
[PIN1 code blocked]
Appears when power is turned on while PIN1 code is locked.
Enter correct PUK when prompt appears to disable PIN lock.
n
P. 131
[Please enter security code]
Appears when a restricted operation was attempted while
Function lock is set. Enter correct terminal security code to
temporarily disable Function lock and continue operation.
n
P. 134
dv55_E.book 494 ページ ２００８年５月６日 火曜日 午前９時８分
