110CT/CR/FB Ice and Water Dispensers
23
Ice transport tube replacement – Top mount units
Models 110CT425A/W
CAUTION!
§
Use only tubing supplied by Follett Corporation.
Tighten clamp
screw
1.00" (2.54 cm)
2
1
3
Ice transport tube replacement – Freestanding and RIDE models
Models 110FB425A/W, 110CR425A/W
CAUTION!
§
Correct installation of ice transport tube is critical to RIDE ice machine performance. Replacement ice
transport tubes for RIDE ice machines must be insulated and run continuously from ice machine to
dispenser with no dips or bends with a radius of less than 6" (15.3 cm).
1. Remove top and rear access panel from dispenser (lower front panel in freestanding unit).
2. Disconnect existing ice tube from engaging pin on transport tube bracket in ice storage bin and pull
down through dispenser chase.
3. Disconnect opposite end of tube from ice machine.
4. Run end of new ice transport tube with 3/16" (5 mm) hole through ice transport tube knockout in back
of dispenser or through counter into bottom of dispenser, being careful to avoid any bends with less
than 6" (15.3 cm) radius.
5. Insert tube in internal chase in rear inside corner of dispenser (left side as you face dispenser) and
push up into storage area.
6. Push the 3/16" (5 mm) hole near end of tube into pin on ice tube bracket (Fig. 8).
Fig. 7
A
A
1.00"
(2.54 cm)
Section A – A
3/16" (5 mm)
dia. hole
engaging pin
3/16" (5 mm) ice tube hole
ice hose mounting bracket
ice level control stat
ice tube
1.00"
(2.54 cm)
