24
110CT/CR/FB Ice and Water Dispensers
Steps 7-8 for units with RIDE ice machines only
7. Install supplied insulation to run of
transport tube required for your site,
leaving approximately 2" (5.1 cm) of tube
exposed at free end.
8. Check that insulated tube runs
continuously from ice machine to
dispenser with no dips.
9. Heat end of transport tube in cup of 160 F
(71 C) hot water to soften and spread with
pliers before making connection to ease
assembly and prevent coupler edge from
cutting inner wall of tube (Fig. 8).
Fig. 8
Hot Water
160 F (71 C)
All units
10. Slip supplied hose clamp onto tube and push tube onto exit port of evaporator.
Do not twist hose
when securing to evaporator.
Note: Only use tubing supplied by Follett Corporation.
11. Fasten tube on port with hose clamp, ensure that clamp is positioned on evaporator side of nozzle
flange.
12. Tighten clamp.
