50
GRINDING OTHER REELS
PLACE A CUTTING UNIT NOT LISTED ON THE ACCU-REEL POSITIONER
If the cutting unit is not listed on the menu on the left side of the ACCU-REEL POSITIONER you will need
to use the
POSITION LOCK on the right side of the ACCU-REEL POSITIONER.
INSTALL CUTTING UNIT
1. Pull up on the POSITION LOCK
PIN
and turn it 90° to lock it in the
UP
position (see FIG. 83).
2. Move the right side KNOB to the UNLOCK position See FIG. 83.
3. Move the cutting unit to the approximate grinding position by placing the rear roller into the V-blocks on
the ACCU-REEL POSITIONER. Move the cutting unit on the ACCU-REEL POSITIONER forward or backward
until the center shaft of the reel is positioned so that it is at a one o’clock, or 30° angle, (looking from the
right side) position in reference to the
GRINDING WHEEL
. See FIG 84. Turn the RIGHT SIDE KNOB to the
LOCK position.
4. Continue with the setup process as shown on Page 31.
MAKE SURE THE GRINDING WHEEL IS LOW ENOUGH TO CLEAR THE REEL. YOU CAN LOWER THE
GRINDING WHEEL BY PRESSING THE OUTFEED BUTTON.
NOTE:
To adjust the RELIEF ANGLE ADJUSTER turn the knob clockwise for more clearance or counter
clockwise for less clearance until you have reached the desired angle See page 44 for details.
Place the rear roller of the cutting unit into the
V-Blocks on the ACCU-R
EEL POSITIONER
ensuring the
FRONT HEIGHT ADJUSTER
is in a position to receive
the front roller. Clamp the rear roller
FIG. 85
FIG. 86
FIG. 83
V-BLOCKS
FRONT TOOLING
REAR ROLLER CLAMP
LOCK KNOB
T-HANDLE
FIG. 84
REEL
FRONT ROLLER
CLAMP
REAR ROLLER
GRINDING
WHEEL