47
OPERATION
RELIEF GRIND PROGRAM
1.
Select a program from the 5
PRESET PROGRAMS
or, if there are programs that were previously saved,
press LOAD to access the Program Load Screen. You may edit the values by pressing on the value. A
screen will appear that will allow you to type in a new value. Press ENTER to load the new value into
the control.
2.
When the values displayed are correct, press the GREEN CHECK in the lower right corner of the screen.
3.
To start the RELIEF GRIND PROGRAM press RUN PROGRAM. The CONTROL will turn on all necessary
functions. You should watch the grinder to ensure that it is cycling properly.
4.
If the grind is too light touch the QUICK INFEED .001" to infeed the wheel .001" while the program is
running. The wheel will infeed .001" each time you touch the button. Touch QUICK OUTFEED .001" to
lower the GRINDING HEAD CARRIAGE and move the GRINDING WHEEL away from the reel.
5.
If you wish to inspect the reel in the middle of a grind program, press PAUSE. The program will finish
the traverse cycle it is currently on and then stop at the HOME position. You can then open the doors
and check the reel. If you wish to continue press RUN.
SELECT A PRE-SET
PROGRAM
LOAD A SAVED
PROGRAM
VERIFY BLADE
COUNT
INPUT NUMBER
OF INFEEDS
PRESS WHEN YOU
HAVE SET DESIRED
PARAMETERS
INPUT AMOUNT
OF INFEED IN .001"
FIG. 76
RELIEF PROGRAM SCREEN
RUN/PAUSE
PROGRAM
CANCEL/END
CYCLES REMAINING
BLADE NUMBER
RELIEF TORQUE
LEVEL INDICATOR
OUTFEED BY .001"
INFEED BY .001"
DECREASE TORQUE
INCREASE TORQUE
FIG. 77