25
OPERATION
Select a 7" reel then change RELIEF ANGLE ADJUSTER to the corresponding
12°
relief angle
BOTTOM OF FLAG
LOCK PIN
V-BLOCK
RELIEF ANGLE ADJUSTER
SELECT REEL MANUFACTURER AND DIAMETER
Place the ACCU-
REEL POSITIONER
to the correct position based on manufacturer and reel diameter. To
move the ACCU-REEL POSITIONER pull up on the lock pin and move the assembly to the desired position.
To lock the assembly in the correct position release the lock pin and move the assembly until the lock pin
locks into position.
Set your relief angle to the preset angle using the
RELIEF ANGLE ADJUSTER.
SEE PAGE 41.
To move the
RELIEF ANGLE POSITIONER turn the knob clockwise or counter clockwise until you reach the desired relief
angle. NOTE: Grinding head must be in RELIEF position and the angle is set from the bottom edge of the
FLAG. See FIG. 26.
Example: On a 7" Jacobsen reel you will set the ACCU-REEL POSITIONER (as shown in FIG. 25) and then
set the relief to the corresponding 12° angle (as shown in FIG. 26). If the reel you are grinding does not fit
these parameters see the "GRINDING OTHER CUTTING UNITS
" section on page 50.
RELIEF ANGLE
INDICATOR
FIG. 23
FIG. 24
FIG. 25
FIG. 26