38
OPERATION
FIG. 56
INFEED
START
TRAVERSE
SPIN DRIVE
MOTOR
SPEED LEVEL
INDICATOR
TEST GRIND
1.
Close the doors (the grinding wheel motor and
spin drive will not operate with the doors open).
2.
Press START. This will turn on the
GRINDING WHEEL MOTOR, VACUUM,
and the SPIN DRIVE MOTOR.
NOTE: When the reel turns in the same rotation
as the grinding wheel, the point of contact
where they meet is in opposite directions. See
FIG. 57. If this is not correct turn off grinder and
go back to the spin motor position screen.
3.
With the grinding wheel under the reel,
press the
INFEED icon on the
ACCU-
TOUCH 3 CONTROL
until there is light
sparking on the reel.
4. Press THE TRAVERSE icon on the
ACCU-TOUCH
3 CONTROL
to traverse across the reel to find
the high areas and test the travel limits.
NOTE: If the grind starts getting heavier, lower
the grinding head until you can travel the full
length of the reel without heavy grinding.
5.
Traverse to the
HOME POSITION.
NOTE: The Home position is when the grinding
head is on the right side travel limit and the right
side travel limit sensor is illuminated.
NOTE: if there is excessive differences from one
side to the other (more than 1/16" [1.5mm]
you may want to verify alignment before going
further.
6.
With the wheel in the home position
press
STOP
, then press
FORWARD
to continue on to the next screen to
select a program.
FIG. 57