Focus Gyrofocus, Инструкция по установке, обслуживанию и эксплуатации

Страница: 23 / 36

23
Installer information
SPARE PARTS
Burner, Curve Natural BG10305
Burner, Curve LPG BG1030A
Pilot Natural (ODS) CG06178
Pilot LPG (ODS) CG20078
Injector Natural (Stereomatic Marking, 1200) CG67077
Injector LPG (Stereomatic Marking - 400) YG75077
Control Valve (Mertik GV60) CG20879
Full Control Remote Symax CG20879-2
To replace these items, follow the procedure listed in the servicing
instructions above.
TROUBLESHOOTING
Pilot sparks but does not light –
No gas to fire, check isolators are open.
Pipework blockage, clean out.
Air not fully purged, repurge supply or wait longer.
Spark earthing to metal work, reset gap correctly.
Check for spilled ceramics in pilot area.
Blocked pilot, clean out internally.
Pilot lights but then goes out –
Severe restriction in gas supply, clear obstruction.
Faulty thermocouple, replace pilot unit.
Hold control knob in for longer.
Check control knob does not foul control plate.
Fire does not spark at pilot –
HT lead detached, refit.
Spark gap too large or small, reset correctly.
Faulty piezo unit, replace.
Debris shorting out electrode, clean.
Fire runs for a time and then cuts off –
Excessive room draught or flue pull, rectify.
Loose or faulty thermocouple, rectify.
ODS system in operation.
Lint in pilot aeration hole, clean thoroughly internally
Pilot flame shrinks when fire is on high –
Poor gas flow to fire, check pressure with fire on high.
If pressure is low, remove any restriction in pipework or valve.
Check all isolators are adequately sized and fully open.
Check meter pressure is adequate.
Lint in pilot aeration hole, clean thoroughly internally.
Fire smells when first lit or in use –
Newness smell from brand new appliance.
Spillage occurring. Carry out spillage test and rectify any problems.
Low temperature sealants or combustible materials used in incorrect
positions.