www.fmiproducts.com
116647-01H
28
FIREPLACE INSTALLATION
Continued
Figure 47 - Installing the WRC Remote
Receiver
Fireplace
Receptacle
Remote
Control
Receiver
Extension Cord
Ignition Module
Plug
Figure 48 - Installing Battery into Back
of Handset
Battery Cover
12 Volt Battery
Back of
Handset
Pull to Remove
Insulation Tab
WALL SWITCH INSTALLATION
The installation of a wall switch allows you to ac-
tivate the gas control valve and turn the fireplace
on and off. The wall switch is to be connected
to the incoming 120 volt regular household wir-
ing that supplies the electricity to the fireplace.
OPTIONAL REMOTE CONTROL
INSTALLATION (Model
WRC)
Note:
If using optional wireless hand-held re-
mote control, the wall switch must be in the ON
position to be operational. The remote control
then becomes the switching mechanism for
fireplace operation.
1. Open lower louver panel.
2. The WRC model receiver does not require a
battery. The receiver can be installed by first
plugging the short extension cord into the
fireplace receptacle. Then plug the receiver
unit into the extension cord. Finally plug the
ignition module plug into the receiver unit
(see Figure 47).
3. Activate the remote handset battery by
removing the insulating tab on the back of
the handset (see Figure 48). The battery
is included pre-installed.
4. Once the battery is activated the unit is
ready to use.
5. Close lower louver panel.
EV2
EV1
ORANGE
IGNITOR LEAD
GREEN
PILOT
TRANSFORMER
IS1070
B
SYNETEK CONTROLS IN
C
24V AC
E4
E2
E3
E6
RED
E8
E12
BLUE
120V AC
GROUND
BLACK
WHITE
WIRING DIAGRAM