www.fmiproducts.com
116647-01H
25
Replacing Screen Door Assembly (TC32
Series)
Push magnetic door latch out to the open
position. Position screen door tabs with slot
openings in upper face frame. Swing door
screen assembly in towards the bottom face,
Press in on the bottom of door screen until
magnetic door latch is pushed in.
Removing Glass Door
If replacement of glass is necessary, the entire
assembly, glass and frame, must be replaced.
If glass is broken, wear gloves and tape the
remaining fragments onto the frame.
1. Remove screen assembly by pushing the
rod either left or right and then down and
forward to remove screen/rod assembly
from the firebox. Set assembly aside.
2. Lift up on latches to unlock. There are two
on top of firebox and two below firebox that
hold glass door in place (see Figure 38).
3. While holding glass door to prevent it from
falling and causing injury, remove the five
screws from the hinge located on the left side
of door frame assembly (see Figure 38).
4. Remount the new frame at the hinge with
five new screws before closing door. This
will ensure seating of the gasket.
5. Close glass door frame. Lock latches by plac-
ing the bar under the tab on door and pushing
down and back on latch (see Figure 38).
6. Replace screen/rod assembly by revers-
ing step 1.
7. Replace louvers by reversing procedure
under
Removing Louver Panels
, for T32
series.
8. Replace screen door assembly, see remov-
ing screen door assembly, (for TC32 series).
Cleaning Glass Door
See
Cleaning and Maintenance
on page 30.
FIREPLACE INSTALLATION
Continued
Figure 36 - Removing Louver Panel
Louver Panel
Spring Latch
Figure 38 - Removing/Replacing Glass
Door
Lock
Unlock
Glass Frame
Assembly
Screw
Hinge
Latch
Figure 37 - Removing/Replacing Screen
Door Assembly (TC32 Series)
Magnetic Door Latches
(TC32 Series)
Door Screen Tabs
(TC32 Series)
Slots underneath
Upper Face
Removing Louver Panels
Remove the top and bottom louver panels by
simultaneously pulling both top end spring
latches towards the center of the appliance
until they are disengaged from the locating
holes (see Figure 36). Repeat for bottom
spring latches and pull the louvers outward.
To install or replace items removed, simply
reverse the procedures above.
Removing Screen Door Assembly (TC32
Series)
Push screen door assembly in toward the
bottom left and right sides until the magnetic
door latch pops the screen door out. Hold
the screen door assembly at the bottom and
swing the door up to disengage the tabs on
the top of the door from inside the slots un-
derneath the upper face.
