www.fmiproducts.com
116647-01H
27
Figure 44 - Installing Log No. 4
Figure 45 - Installing Logs No. 5 and No. 6
FIREPLACE INSTALLATION
Continued
5. Place log #5 (base log) onto front left part
of grate making sure log fits over metal pin
of grate. See Figure 45.
6. Place log #6 (left log) onto pin on left side
of front log, the rear part of log rests over
the log no. 1 (See Figure 45).
Ember Material
Figure 46 - Placing Ember Material on
Burner
2. Rest log #2 (front log) on pins on front part
of grate (see Figure 42).
Figure 42 - Installing Log No. 2
Figure 43 - Installing Log No. 3
2
Grate
Metal
Pins
3
Metal
Pin
Rear Log
Front Log
4
Log
Landing
Front Log
3. Place log #3 (crossover log) onto front log.
Make sure it is seated properly on surface
of rear log and pin on front log as shown
in Figure 43.
4.
Place log #4 (right log) onto the landing on
right side of front log as shown in Figure 44.
5
6
Metal
Pins
Rear Log
7. Place lava rock along sides and front of
firebox bottom in areas that are visible
only. It is not necessary to use all of the
lava rock provided.
NOTICE: Do not put lava rock on
burner or under burner. Placing
lava rock on burner will cause
performance problems.
8. Pull ember material apart into pieces no
larger than a dime. Place these pieces
loosely and sparingly directly onto exposed
section of front burner and along space
between burner and grate prongs (see
Figure 46). This will create the glowing
ember appearance as the flame touches
the ember material. Do not block air slots
by using too much ember material in one
area. Place small pieces of ember material
to cover pilot ports. It is not necessary to
use all of the ember material provided.
9. Close glass door, lock door latches, replace
screen and close louvers (see steps 5 and
7 of
Removing Glass Door
, page 25).