www.fmiproducts.com
112127-01C
28
BURNER FLAME PATTERN
Burner flames will be steady; not lifting or float
-
ing. Flame patterns will be different from unit
to unit and will vary depending on installation
type and weather conditions.
If the vent configuration is installed incorrectly,
the flames will lift or “ghost”. This can be dan
-
gerous. Inspect the flames after installation to
ensure proper installation and performance.
Figure 47 shows a typical flame pattern. If
burner flame pattern differs from that de
-
scribed:
• turn burner system off (see
To Turn Off Gas
to Appliance
, page 27)
• see
Troubleshooting
, page 30
Figure 46 - Pilot Assembly
Thermopile
Thermocouple
Pilot
Burner
Piezo Ignitor
3/8" to 1/2"
Figure 47 - Typical Flame Pattern
insPeCtinG Burners
Check pilot flame pattern and burner flame
patterns often.
PILOT ASSEMBLy
The pilot assembly is factory preset for the
proper flame height. Alterations may have
occurred during shipping and handling. Call
a qualified service person to readjust the pilot
if necessary.
The height of the thermopile must be 3/8" to
1/2" above the pilot flame as shown in Figure
46. The flame from the pilot burner must ex
-
tend beyond the thermopile.
If your pilot assembly does not meet these
requirements:
• turn burner system off (see
To Turn Off Gas
to Appliance
, page 27)
• see
Troubleshooting
, page 30
CLeaninG and maintenanCe
WARNING: Turn off burner
system and let cool before
cleaning.
CAUTION: you must keep
control areas, burners, and
circulating air passageways of
stove with burner system clean.
Inspect these areas of stove and
burner system before each use.
Have burner system inspected
yearly by a qualified service
person. Burner system may need
more frequent cleaning due to
excessive lint from carpeting,
bedding material, pet hair, etc.
GLASS DOOR
WARNING: Handle glass
door panel with care. Do not
strike, slam or otherwise abuse
glass. Do not operate burner
system with the glass door re
-
moved, cracked, or broken.
WARNING: Do not use abra
-
sive cleaners as this may dam-
age glass. Use a non-abrasive
household glass cleaner to
clean glass. Do not clean glass
when hot.
