www.fmiproducts.com
112127-01C
4
5. You must keep control compartments,
burners and circulating air passages
clean. More frequent cleaning may be
needed due to excessive lint and dust
from carpeting, bedding material, etc.
Turn off the gas valve and pilot light before
cleaning stove or burner system.
6. Have venting system inspected annually by
a qualified service person. If needed, have
venting system cleaned or repaired. See
Cleaning and Maintenance
, page 34.
7. Do not use any solid fuels (wood, coal,
paper, cardboard, etc.) in this burner
system. Use only the gas type indicated
on burner system nameplate.
8. This appliance, when installed, must be
electrically grounded in accordance with
local codes or, in the absence of local
codes, with the
National Electrical Code,
ANSI/NFPA 70.
9. Do not use stove or burner system if any
part has been exposed to or under water.
saFety
Continued
Figure 1 - FMI PRODUCTS, LLC Direct Vent Burner System Shown Installed in
Approved FMI PRODUCTS, LLC Cast Iron Stove Body (Oxford™ Model Shown)
Blower with
Adjustment
Knob (Optional
Installation)
Pilot
Assembly
Burner
Vent Opening
Glowing
Embers
Grate
Assembly
Rear
Cover
Cast Iron Stove Body
Lava
Rock
Cast Iron
Stove Body
Piezo
Ignitor
Control
Valve
Log
Set
Stove
Front
Immediately call a qualified service person
to arrange for replacement of the unit.
10. Do not operate burner system if any log
is broken.
11. Do not operate burner system with glass
door removed, cracked or broken.
12. Do not obstruct the flow of combustion
and ventilation air in any way. Provide
adequate clearances around air open-
ings into the combustion chamber along
with adequate accessibility clearance for
servicing and proper operation.
13. Do not install stove with burner system
directly on carpeting, vinyl tile, or any
combustible material other than wood.
The stove must set on a metal or wood
panel extending the full width and depth
of the stove.
14. This stove must be properly connected
to a vent system. This stove is equipped
with a vent safety shutoff system.
LoCaL Codes
Install and use stove and burner system with
care. Follow all local codes. In the absence
to local codes, use the current
National Fuel
Gas Code ANSI Z223.1/NFPA 54*
.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
ProduCt identiFiCation
