www.fmiproducts.com
126364-01A
29
OPERATION
Continued
Figure 62 - Pilot (Natural)
Thermocouple
Ignitor Electrode
Pilot Burner
REGULATING THE FLAME LEVEL.
1.
To increase the flame level, press the
up button (
). A beep and a flash of
the LED indicate that the system has
accepted the order, and the flame will
increase instantly (see Figure 61, page
28).
2.
To decrease the flame level, press the
down button ( ). A beep and a flash
of the LED indicate that the system
has accepted the order, and the flame
will decrease instantly (see Figure 61,
page 28).
SWITCHING OFF
To switch off the fire, the ON/OFF button
should be pressed. After the system has emit-
ted a beep, the fire switches off.
WARNING: Do not convert
heater to use different fuel type.
Only use heater with fuel type
specified.
BLOWER
OPERATION
WARNING: This fireplace has
a three-prong, grounded electri
-
cal plug. This plug helps protect
you against electrical shock.
Only connect plug to a properly
grounded, three-prong recep
-
tacle. Do not cut or remove the
grounding prong from this plug.
Access the blower control knob by pushing in
on the bottom corners of the fireplace screen,
grasp the bottom of the screen and pull out
and up to remove the screen. The blower
control knob is located on the left side of the
fireplace floor.
The blower is thermostatically controlled. This
means the fireplace and blower will not turn
on and off at the same time. The fireplace
may run for several minutes before the blower
turns on. After the fireplace is shut off, the
blower will continue to operate until the fire
-
place temperature cools.
The blower also includes a variable speed
control. Turn the knob clockwise to turn the
blower to the high position. Continuing to turn
the knob will reduce the speed of the blower
until it reaches a preset low speed.
