www.fmiproducts.com
126364-01A
26
OPERATION
Continued
Figure 53 - Adjusting Menu
Available
after
PROGRAM
MODE is
enabled, see
PROGRAM
MODE
section on
next page.
SETTING THE CONTROL MODE
There are three different modes for controlling
the appliance:
Manual
Auto
Program
In Manual mode the main burner can be
switched on and off.
Auto mode allows you to set a temperature,
while in Manual mode the flame level may
be set to HIGH, MEDIUM, or LOW. Program
mode offers automatic temperature control for
specific times of the day.
In the initial screen when the remote is
turned on, three options are available: AUTO,
MANUAL and MENU.
Auto and Manual are two of the three differ
-
ent modes for controlling the appliance with
the remote.
MANUAL MODE
If ''Manual'' is pressed, the flame setting ap
-
pears as the selected setting. In the bottom
row,
and
appear, indicating that the flame
level can be changed by pressing the left or
middle button. Pressing ''Back'' (right button)
returns to the initial screen (see Figure 51,
page 25).
Note that a safety temperature can be set
in the configuration menu. This specifies
the maximum the maximum permitted room
temperature. This temperature can never be
set higher than 40ºC (104ºF).
AUTO MODE
If ''Auto'' is pressed in the initial screen, 25ºC
(77ºF) appears as the desired temperature in
the selected setting. In the bottom row,
and
appear, indicating that we can change the
desired temperature value by just pressing the
left or middle button. In auto mode the appli-
ance heats until this temperature is reached.
Pressing ''Back'' (right button), returns to the
initial screen.
The Auto mode feature is optional and can
be enabled or disabled in the configuration
menu by changing ''Thermostat'' to either
''Yes'' (enabled) or to ''No'' (disabled). Access
to the configuration menu is described in the
next section.
PROGRAMMING
PROGRAM MODE
A program mode is available if desired. This
mode allows the remote control to operate
the gas log set in either weekly or daily set
-
tings. To enable the program mode access
the configuration menu.
CONFIGURATION MENU ACCESS: Press
and hold the “OFF” button
on the remote
control for 40 seconds. During this time, the
screen will go blank for a few seconds, this
is normal. See Figure 54. After 40 seconds,
the configuration menu appears (see Figure
55, page 27).
Figure 54 - OFF Button
OFF Button
Fri 20:45
Lock
Menu
On
OFF
°F
75
u
Configuration
Select Back
Off
No
Yes
0.5°C
Thermostat
Programming
Gap Temp
Fri 22:04
Pairing
Press the arrow button
( ) until Programming
is highlighted (see Figure 55). If Program-
ming has ''No'' next to it, press the ''Select''
button to highlight ''No'' (see Figures 55 and
56, page 27).
