Website
19
binding operation and the Quick Start Guide.
3.
After finishing the above step, carry out a test to confirm that all channel outputs are
functioning as expected.
6.24 Receiver Settings - Sensor
As an interesting feature for two-way communication systems, sensors can be used to send back
some information you need through the receiver.
Our transmitter can support up to 15 different types of returned data to provide you with the
feedback of seven basic parameters, i.e., TX VOL(TX voltage), RX VOL(RX voltage), BVD VOL(BVD
voltage), SIGNAL(signal intensity), NOISE, SNR(noise rate) and RSSI. BVD: detect an external
power supply. It is recommended to use this function to monitor the battery voltage and give an
alarm in case of a failure.
Function settings:
In the SENSOR menu, scroll pages by pressing the UP/DOWN key to check relevant information.
6.25 Receiver Settings - ESC Settings
The ESC SET(ESC Setting) menu is an additional option provided specially for FLYSKY two-in-
one ESC, which is used to set the two-in-one governor more precisely to ensure its optimal
performance. To enable this setting, you need to switch the receiver type to the two-in-one option
in the Receiver settings - Bind Setting menu.
6.23 Receiver Settings - Range Test
As an important function, it is recommended to conduct the range test before each operation to
check whether the remote controller is functional or environmental conditions are normal.
Working principle: It is aimed to conduct a narrow-ranged test by actively reducing the power
of the transmitter, in order to realize quick inspection of the transmitter system and the
environment. There are three parameters (power, signal, RSSI) displayed and indicated on the
transmitter interface.
Function settings:
1.
In the RANGE TEST menu, directly press the SW2 key to conduct the test.
2.
You should keep the transmitter still during the test, but you can move your model at this
time. If there is no problem in the test within a certain range, the device can be used normally.
Note
: The transmitter is compatible with i-BUS sensors, such as FS-CPD01 magnetic speed sensor,
FS-CPD02 optical speed sensor, FS-CVT01 voltage sensor, FS-CTM01 temperature sensor and FS-
CAT01 altitude sensor.
