FS-G7P
Digital Proportional Radio Control System
Website
12
This function can be used to set pulse braking, namely the brakes are released periodically when
braking is triggered, to prevent skid, drift or under-turning due to locked wheels.
There are seven items for A.B.S. function setting, including
USE
,
RETURN
,
DELAY
,
CYCLE
,
POINT
,
DUTY
, and
ST MIXING
.
USE
: To turn on or off the function. Set it to on to turn on the function, and the default is OFF.
RETURN
: Controls the reduction of braking during each pulse. It can be set to any value between
0% and 100%, and the step value is 1%. By default it is set to 50%. If set to 60%, when the brakes
are active; the system will remove 60% of the brakes strength on each pulse. When it is set to
100%, there is no brake.
DELAY
: Determines how long it takes for the A.B.S. system to take effect. It can be set to any value
between 0% and 100%, and the step value is 1%. By default it is set to 0%. At a setting of 0%,
theA.B.S. system will take effect as soon as the brake is applied. The higher the value, thelonger
it will take for the A.B.S. to function. When set to 0% there will be no delay, meaning the breaks
will be applied as soon asthey are triggered. The maximum setting of 100% will result in a delay
of 2 seconds.
CYCLE
: It is used to set the interval between pulses. The setting range is 20% to 100%, and the
step value is 1%. The default value is 50%. The larger the value, the longer the interval time
between pulses. The value 100% indicates the interval is 0.5S.
POINT: It is used to set the start position of pulse brake function. The setting range is 10% to
100%, and the step value is 1%. The default value is 30%. The higher the value, the closer the
stick position that triggers the pulse brake function is to the full brake position. 0%-100% is the
entire travel movement amount of the throttle trigger.
DUTY
: To set the braking - release cycle length in pulse braking between -4 and +4. Default: 0,
that is, the time for release the brake and the brake are same, when the value is changed, the
peak and trough lengths of the brake pulse's square wave change accordingly. You can adjust the
ratio between braking and release. The rate is 1:1 when the cycle length is set to "0". The rate is 1:2
when the cycle length is set to "1". And the rate is 2:1 when the cycle length is set to "-1". A.B.S.
can be reduced automatically while turning. This function mixes braking and steering to turn
reduce the A.B.S. or replace it with a constant braking pressure. The percentage represents the
trigger position through its entire range of movement. E represents inside, N represents outside;
if 50% N is set, the ABS function is active when within 50% (10%N-50% N), and outside 50% (50%
N-100% N) is to turn off the ABS function; If 50% E is set, the ABS function will be turned off
within 50% (10%E-50% E), and the ABS function will be turned on outside 50% (50%
E-100% E).
Function settings:
1.
In the SET menu, select the ABS function and press the OK key.
2.
Select the item you need to adjust by pressing the UP/DOWN key. Press the OK key to enter
the edit state. Then adjust it by pressing the UP/DOWN. Press return after adjustment.
3.
Test the function to confirm that all channel outputs operate normally as expected.
6.8 Settings-ABS