Website
13
6.9 Settings-IDLE UP
6.10 Settings-ENG CUT
The throttle idle up function is used to set the engine idle speed when the fuel car is in the
neutral position. After setting the idle speed, you can preheat the engine in order to keep it from
stalling.
There are three items for IDLE UP function setting, including USE, TYPE, and RATE.
USE
: To turn on or off the function.
TYPE
: Select a mode between NORMAL and LOCKING, For NORMAL mode, when pulling the trigger
backwards, the channel data continues to decrease. For LOCKING mode, the channel output data
is locked at the value set when pulling the trigger backwards.
RATE
: To set a value for IDLE UP. It can be set to any value between -50% and 50%, and the step
value is 1%. By default it is set to 0%.
Function settings:
1.
In the SET menu, select the IDLE UP function and press the OK key.
2.
Select the item you need to adjust by pressing the UP/DOWN key. Press the OK key to enter
the edit state. Then adjust it by pressing the UP/DOWN. Press return after adjustment.
3.
Test the function to confirm that all channel outputs operate normally as expected.
When Engine Cut is triggered, the throttle channel will output the predefined value, and the
throttle trigger cannot control the output value of the throttle channel.
There are thtwo items for it, including USE and RATE.
USE
: To turn on or off the function.
RATE
: To set a predefined value for ENG CUT. It can be set to any value between -100% and
100%,By default it is set to 0%. And the step value is 1%.
Function settings:
1.
In the SET menu, select the ENG CUT function and press the OK key.
2.
Select the item you need to adjust by pressing the UP/DOWN key. Press the OK key to enter
the edit state. Then adjust it by pressing the UP/DOWN. Press return after adjustment.
3.
Test the function to confirm that all channel outputs operate normally as expected.
