Chapter 7
Task Navigator
This function is useful to override the automatic task navigation provided by the NAV , and should
only be used if for some reason a mistake was made during the creation of the task.
When this option is selected the NAV displays the task list. Using the UP and DOWN buttons
the desired waypoint can be selected. Pressing the ENTER button will cause navigation to be
resumed to the selected waypoint. Route navigation will then continue in the sequence displayed in
the task menu.
Figure 7.1: Task Navigator
When entering into the Task Navigator menu, all of the route points are shown as both the short
name and long name (Figure
7.1
). Selecting any of the routepoints will show a navigation wheel
in the lower part of the screen showing the direction to that point along with the distance to the
waypoint cylinder. The distance shown is the Distance to Line, which is the closest point on the
cylinder to where the pilot is. This is not necessarily the optimum point on the cylinder.
The
Start
waypoint will be grayed since it is not possible to navigate to a start. Pressing the
menu button will get you back to the flight screen without any change to the navigation.
Note that an override to the navigation will assume that the start has been done.
34
Содержание NAV
Страница 1: ...User manual Document version 3 4...
Страница 25: ...24...
Страница 37: ...Figure 8 2 Critical Airspace Data 36...
Страница 61: ...Figure 14 1 Firmware Update 60...