Serial Receiver support
The KISSESC32A supports Serial Receivers. It auto detects on the input (Sig. | RX). As it doesn‘t
deliver 5V, the Receiver must be powered externally.
1. FrSky Sbus and S-Port.
Connect the Sbus Output to Sig. | RX pin. And if you need Telemetry connect S-Port to TLM | TX.
If a valid Sbus signal is detected, S-Port becomes active automatically.
The ESC uses Sbus channel 0 as default throttle channel. It can be changed in the CLI interface.
For S-Port its default senor adress is 27. It can be changed in the CLI interface.
Available telemetry:
- Voltage (Volt)
- Current (Ampere)
- Consumption (mA/h)
- Temperature (°C)
- RpM (Default for 14 Magnetpole Motor, confugurable in CLI)
2. Graupner SumD and HOTT
Connect the SumD Output to Sig. | RX pin. And if you need Telemetry, HOTT to TLM | TX. If a valid
SumD signal is detected, HOTT gets automatically active.
The ESC uses as default throttle channel SumD channel 0. it can be changed in CLI interface.
In the HOTT telemetry it will be found as Electricl Air Module.
Available telemetry:
- Voltage (Volt)
- Current (Ampere)
- Consumption (mA/h)
- Temperature (°C)
- RpM (Default for 14 Magnetpole Motor, confugurable in CLI)
