>SRx: set MPX SRXL Chan. x=0...7
>MSxx: set MPX Sensorbus offset xx=00...11
>SDx: set GR SumD Chan. X=0...7
Software updates
The KISSESC32A comes with a KISS bootloader to gain easy updates using the signal input wire
over a FC or USB-UART.
Software update through the KISSFC
Here you dont need to change any connection as the wiring is similar to how it is needed to fly
1. remove all propellers!
2. connect the FC to your PC
3. power the ESC's
4. open the KISS GUI and connect to the FC
5. go to ESC Flasher tab, select a FW and start the flash process.
Software update through Betaflight
you will need the KISS Flash Loader app.
1. remove all propellers!
2. connect the FC to your PC
3. power the ESC's
4. open the Betaflight GUI, go to CLI and type in „
escprog ki 255
“
5. close the com port!
6. open the KISS Flash Loader and select USB-UART
7. select the firmware you like to flash and start the Flash process
Software update via USB-UART
you will need the KISS Flash Loader app.
Connect the USB-UART like that:
ESC
USB-UART
Signal in
GND
↔
↔
TX
GND
1. remove all propellers!
2. connect the USB-UART to your PC
3. power the ESC
4. open the KISS Flash Loader and select USB-UART
5. select the firmware you like to flash and start the Flash process.
