ELIOS 3 User Manual
9.6. Changing an LED:
R
EQUIRED TOOLS
(Y
OU WILL FIND ALL THOSE TOOLS WITHIN THE PROVIDED TOOLBOX
):
1.
Torx T6 screwdriver.
LED
PANELS MUST BE REPLACED ONE BY ONE
,
NEVER REMOVE
SEVERAL PANELS AT THE SAME TIME
.
Here is the step-by-step procedure on how to change an LED panel:
●
Remove the top and bottom screw of the panel you need to replace.
●
Remove the panel by pulling it out in the direction of the front of the drone.
●
Once the panel is out, gently pull on it to get the cable out.
●
Disconnect the cable by gently pushing down the lever of the connector while wiggling it to unplug.
●
Only one cable is connected on the outermost panels.
●
On the central (near the camera) panel you have two cables. The one with the red ring must be
connected to the connector closest to the camera.
●
Take the new LED panel.
●
Connect the cable (or cables).
●
Slide the panel in. Pay attention to the panel sliding above the plastic tabs and under the plastic frame.
●
Place the top and down screws and tighten them. Don’t apply extreme force, just enough to block the
screw in place.
●
Connect the system to check that the LED works again.
O
NLY USE
F
LYABILITY GENUINE REPLACEMENT PARTS
.
To learn more about this topic, please watch the related support video. Support videos can be found
ELIOS 3 User Guide
Page 93 of 94
Содержание Elios 3
Страница 27: ...ELIOS 3 User Manual 1 Unlock the battery 2 Remove the battery from the drone ELIOS 3 User Guide Page 27 of 94 ...
Страница 52: ...ELIOS 3 User Manual Figure 6 1 Aircraft Firmware Update ELIOS 3 User Guide Page 52 of 94 ...
Страница 69: ...ELIOS 3 User Manual ELIOS 3 User Guide Page 69 of 94 ...