User Manual
E110-P
Page 12
FW_E110-P_M_v0301-01_EN
CLEAR
-key
This key is used to clear the value of total.
The CLEAR-key also provides access to the LOG-mode, to review historical day totals
(or optional data logging).
Selecting displayed information
By pressing the SELECT-key, all relevant information can be reviewed on the display. When no key
is pressed for 20 seconds, the display will jump back to the main screen. The following image of the
display shows the main screen with Total shown on the top line and Flowrate on the bottom line.
Fig. 6:
Example of display information
The following table shows the available display information screens, determined by the configuration
settings for Display. If an operator alarm occurs, this will also be shown on the same screen – see
Section 4.5: Operator alarms [»14]
.
Display information
SETUP
= TOTAL
= FLOWRATE
= ACC. TOTAL
MAIN SCREEN
Total
1)
Flowrate
Flowrate
Total
1)
Acc. Total
SCREEN 1
Total
1)
Acc. Total
Total
1)
Acc. Total
Total
1)
Flowrate
SCREEN 2
2)
Current day Total
SCREEN 3
2)
Previous day Total
INTERNAL ERROR
3)
Internal alarm code
1)
When total is shown on the display, it can be cleared (reset to ‘0’) by pressing the CLEAR-key twice.
2)
Only available when day totals are enabled in
SETUP
3.2: DISPLAY > DAY TOTALS [»25]
3)
If an internal error occurs, an additional screen becomes available to show the internal alarm code.
Clearing Total
The measured flow is added to the various counters (like Total) of the unit. Only Total is resettable,
Accumulated total and day totals are non-resettable. The operator can clear Total by executing
following steps:
1. Make sure Total is shown on the display.
2. Push the CLEAR-key.
The display shows the message ‘PUSH CLEAR’ on the bottom line and Total on the top line.
3. To clear Total, push the CLEAR-key again. To cancel the operation, push any other key or wait
for 20 seconds.
4. Check that Total is reset to ‘0’ (this action DOES NOT reset the Accumulated total).
