Florite N920 Series, Руководство по обучению на инструменте

Страница: 48 / 55

Control Type - Output Program
Function
This screen is used to program a desired output control function. A linked input port programmed in
the outputs Port Type provides process measurement information required for the output port to
perform its selected function.
Navigation
Access this screen by using the CHAN key until reaching the desired output port number, and then by
using the PROG key until reaching this screen. . Note the character field blinks indicating readiness
for programming.
Select
Field - select the Control Type using the QTY (right) or CHAN (left) key select one of the following:
ƒ
Monitor
o
Analog output Port Type - converts and outputs its linked input port measurement as an
analog signal which has been scaled using the output port interpolation values.
o
Relay output Port Type - energizes the output relay when the linked input port detects
an alarm condition.
ƒ
Manual - linked input measurements are ignored. The value set in the Control Amount is
converted to an analog value using the output port interpolation values, resulting in a
corresponding analog signal appearing at the output port terminals.
ƒ
Batch - causes the quantity set in the Control Amount to be delivered when a batch process is
started.
ƒ
Dose - causes injector activation when the quantity set in the Control Amount reached.
ƒ
PID - causes linked input rate or value measurement to be continuously maintained to be the
value set in the Control Amount.
Program - save new Control Type selection by pressing the PROG key.