www.florencemailboxes.com
versatile™ 4C Maintenance Manual—206367—Rev A
Page 7 of 64
Care and Cleaning
The surface of all Florence Corporation clear-aluminum or powder-coated products may be cleaned of dirt or grime
with a soft cloth dampened with any mild detergent or properly-diluted biodegradable, water-based cleaner, such
as Simple Green™
1
. Wipe from top to bottom to avoid run-down. Avoid the use of abrasives, which might damage
the product surface. Rinse with plain water and dry
2
. Avoid cleaning during extreme temperature conditions.
To varying extents, depending upon the color, it may be possible to remove some spray-paint or marker-applied
graffiti from powder-coated surfaces by using a stronger cleaner such as Krud Kutter
3
or a mild petroleum-based
solvent, such as mineral spirits. Test-clean a small area first, a few seconds at a time. Do not allow the chemical to
remain on the surface for an indefinite period, as this may damage the surface of the product. Remove any residue
left with a mild cleaner, followed by water rinse as noted above.
Matching paint products may be available from an Authorized Florence Dealer for products which utilize powder
coating.
If a mailbox lock in outdoor equipment becomes clogged with ice due to extreme winter weather conditions, the lock
manufacturer suggests using “
Tri-Flow® Superior Lubricant Aerosol
”
4
. Spray the Tri-Flow® Lubricant
5
directly into
the keyhole and onto the key. Slide the key in and out of the lock several times to spread the lubricant. Do not apply
too much product, as a small amount is sufficient. Wipe off any excess lubricant from the lock and key.
1
Simple Green™, product #13102, is manufactured by Sunshine Makers, Inc. of California, 800-228-0709, [email protected].
2
In foggy coastal regions, frequent cycles of condensation and drying can create a heavy buildup of atmospheric salts and dirt that may
adhere tenaciously. This requires that cleaning be done more frequently than in other metropolitan areas where rainfall is more frequent
(AAMA Standard 609 & 610-02).
3
Krud Kutter™, product #GR32, is manufactured by Supreme Chemicals of Georgia, 800-466-7126, [email protected].
4
Tri-Flow® Superior Lubricant Aerosol, product #TF20009, is manufactured by The Sherwin-Williams Company of Ohio, 800-474-3794.
5
This product is a light-viscosity lube that allows for deep penetration into hard-to-reach moving parts, providing optimum lubrication under
extreme temperatures (-60 to 475° F) and humidity. Product includes formulated solvents that soften and remove dirt and contaminants, and
special additives that displace moisture and prevent rust and corrosion.
versatile™ 4C mailbox suites
Confidential & Proprietary for Florence and Clients Only -- Do Not Distribute
