FLIR Ranger HRC MS, Руководство оператора

Страница: 156 / 260

Ranger HRC™ operator´s manual – System operation
Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
11.4.2.2 Adjustments of FOV and focus
When defining autoscan points, the JCU is used to make adjustments of
field-of-view and focus, as described in the sections below.
Adjusting FOV and focus
1 a
Press the joystick button < 1
second
to go to the next preset field-of-view. Repeat until
the system is at the desired field-of-view.
1 b
Use the and buttons to zoom in/out to the desired field-of-view.
2 Turn the joystick collar to the left/right to focus near/far.
11.4.2.3 Speed and Dwell settings
The Speed and Dwell settings of the autoscan points are made in the
New
pos #
and
Edit pos #
dialog boxes, as described in the sections below.
The Speed setting defines how fast the system shall move to next autoscan
point. The preset speed rates are defined in the
Setup – Pan/tilt
dialog
box, see section 7.6.1.3.
The Dwell setting defines how long the system shall stay on this autoscan
point before moving on to the next point.
Setting Speed and Dwell
1 In the New pos # or Edit pos # dialog box, use the UP/DOWN buttons to select Speed .
2 Use the LEFT/RIGHT buttons to select the speed setting.
NOTE: Hold down the LEFT/RIGHT button for a while to decrease/increase the
speed with larger increments.
3
Use the UP/DOWN buttons to select
Dwell
.
4 Use the LEFT/RIGHT buttons to select the dwell time setting.
NOTE: Hold down the LEFT/RIGHT button for a while to decrease/increase the
time with larger increments.
5 Press the ENTER button to confirm.