FLIR Ranger HRC MS, Руководство оператора

Страница: 117 / 260

Ranger HRC™ operator´s manual – Hardware installation
Publ. No. TM 614 006 699 Rev B – ENGLISH (EN) – Oct 30. 2008
0
Figure 9.3 Holes to use when mounting the cameras
The TV cameras and the Ranger HRC-U camera is mounted with M6 x 20
screws. The Ranger HRC-S camera is mounted with UNC ¼ x ¾ screws.
Mounting the cameras
Step Action
1 Fit the cameras in place, one at the time, on the mounting plates, using the two guiding
pins. It is easiest to start with the front guiding pin and then fit the rear pin in place.
2 Thread the four M6 x 20 or UNC ¼ x ¾ screws into the holes that are marked in Figure
9.3. Tighten the screws and ensure that the Pan/Tilt unit is fastened properly.
NOTE: Do not unscrew the other screws in the mounting plate, as that will
destroy the alignment of the camera.