MAN_DZ7_001 Rev 1.1 Flightcell® DZMx Plus Installation Manual
Page 38 of 61
Effective Date: 28 Jun 2021
1.
Using DZMx Connect app. Select Settings > Tracking > Transmission. Select
one from the list below, select OK and DONE.
2.
Using DZMx Plus Control Head. Select MENU > Tracking > Transmission
Opts > Preferred Device. Select one from the list below:
Select one of the following:
»
Try Sat First: If messages cannot be transmitted over the Iridium satellite
network the DZMx Plus will send them over the cellular network.
»
Try Cell First: If messages cannot be transmitted over the cellular network
(for example if the aircraft is out of cell coverage) the DZMx Plus will send
them over the Iridium satellite network.
»
Sat Only: If the iridium network is the preferred and there is no signal,
tracking messages will be queued.
»
Cell Only: if the cellular network is preferred and there is no signal,
tracking messages will be queued.
Configuring DZMx Plus Tracking Destinations
Once the Tracking Service Provider has your account set up, the DZMx Plus can be
configured to send tracking messages to your selected providers. The destination
gateways for Iridium and cellular networks need to be configured for each tracking
service. The tracing service provider will provide you with their destination address.
The following tracking gateways can be used with the DZMx Plus:
»
Iridium SBD: Destination addresses are configured by your tracking service
provider on the Iridium service SPNet.
»
Iridium SMS: Configure using DZMx Connect. Go to Settings > Tracking >
Transmission, then enter the destination address.
»
Cellular Tracking over IP: Enter the IP address and port number using DZMx
Connect. Go to Settings > Tracking > Transmission.
Configuring Tracking over Internet Protocol (IP) using Cellular Data
If supported by your tracking provider, the DZMx Plus can be configured to send
tracking messages via the cellular data connection to an IP address when a data
connection is available.
1.
Configure the following settings in DZMx Connect: Select Settings > Modem.
Note:
During a satellite call, SBD will be unavailable.
To ensure tracking is not interrupted, the satellite modem will default to
Iridium SMS for tracking, until the call has ended.
Note:
If a method of transmission is not supported by your tracking provider,
leave the destination address setting for that transmission method blank.
