FlexiForce ForceIQ Force100XC, Руководство пользователя

Страница: 24 / 42

manual – force IQ
24
www.flexiforce.com
24
If the door reverses due to a safety edge (OSE, photocell etc.) activation, the red light will be set on both sides at the fully open
position.
If the stop button is pressed, the two way traffic mode is aborted until the door is closed. The light state can be permanent
green/red or red/red in open position depending on when the stop button is pressed. Between the end positions, the light will
continue to flash if the stop button is pressed.
The table shows which side that will have the green light depending on what was triggering the opening. The opposite side has
red light.
Opening command Inside green light Outside green light
Contact unit button X
External up button
(KL20‐1)
X
External one button
(KL20‐7)
X
Radio up button
(KL1‐4)
X
Radio one button
(KL1‐3)
X
Induction loop 1
(KL23‐5)
X
Induction loop 2
(KL23‐4)
X
Press to confirm and save.
Press to return to the "special setup" menu
Press
to return to the main menu.
Press once more to return to
maneuvering mode.
6) CDM6 :
choose enabled if you have a Crawford CDM6 operator connected.
7) Door control mode:
use buttons to select "Sectional door" or "High speed door".
•
Press to return to the main menu.
• Press once more to return to the main menu.
8) External buttons: Use the buttons to choose between
•
Not active:
external push buttons are disconnected if "hold to run" mode occurs in the control box.
•
Active:
the external push buttons can also be used in" hold to run" mode when "hold to run" mode occurs.
•
Press to return to the main menu.
•
Press once more to return to the main menu.
3.4.8. Service
Use the buttons to select one of the following menu items:
1) Cycles
2) Software version
3) CFG XML export
4) Set time
5) Maintenance complete
6) Maintenance intervals
7) Reset errors
8) Event history
9) Clear event history
10) CFG soft reset
11) Factory reset