Flexco FL-L-EC, Инструкция по установке, эксплуатации и обслуживанию

Страница: 39 / 56

39
5.1 Safety Regulations continued
Section 5 – Operation And Handling
Warning!
Risk of overloading when inserting the Flex-Lifter and lifting it from the conveyor frame.
The Flex-Lifter weighs up to approximately 57kg, according to its construction (without a lifting rod for
the return belt).
Ask a second person to assist you when inserting the Flex-Lifter or lifting it from the conveyor frame. If
possible, use a tool to release it.
Information!
Limit the torque of a power tool (power wrench) belonging to a client to a maximum of 52Nm. This is
sufficient for raising the permitted loads.
Do not push against the stop at full torque when lowering. This can damage the thread.
Clean the device regularly, and grease the moving parts on a regular basis, so that the lifting mechanism
will continue to run smoothly.
Please note the safety information in Section 2.5.2.
5.2 Requirements of the Operating Personnel
• The device may only be installed, adjusted and operated by trained personnel who conform to the
requirements.
• The operator is responsible for the selection and training of operating personnel.
• The operator must train the operating personnel in the safety-conscious handling of the device.
• The safety training of the operating personnel by authorized instructors must be repeated on a regular
basis.
• The operating personnel must have read the operating manual or have been informed of its content,
and have fully understood the content.
• Maintenance work may only be carried out by suitably trained, qualified and authorized staff.
5.3 Cleanliness
Before using the device, the workspace should be cleaned of all coarse dirt and discarded objects.