Flexco FL-L-EC, Инструкция по установке, эксплуатации и обслуживанию

Страница: 12 / 56

12
Flex-Lifter Belt Lifters
Section 2 – Safety Information
2.5.2 Residual Hazards continued
Danger!
Unfavorably situated operation sites can pose risks to the operational environment.
• Set up the device so that you can operate it safely.
• Move any obstructions out of the way beforehand.
• Make sure that the installation site is adequately lit.
• Ensure secure positioning and safe access.
• In workstations at heights greater than 0.5 m above the ground, you must take the necessary safety
measures to prevent falls, e.g. construct scaffolding with railings.
• Use the required personal protective equipment, e.g. a protective helmet, protective gloves, protective
footwear, fall protection.
Warning!
The device may tilt, slip or fall during operation.
The raised conveyor belt may be jerky and move downward.
During set-up, ensure that the device is on a flat bearing surface, and has a secure grip on the frame
of the conveyor belt.
The width of the extendable foot sections must be properly adjusted.
The blade pins must all be reinstated and secured with split pins.
The base on which the Flex-Lifter stands, must be designed for the expected maximum load.
Warning!
The device may tilt, slip or fall during operation.
With inclined conveyor belts or inclined installation areas, you are responsible for the stability of
the device, even when it is in its fully extended state.
In this case, you must also securely attach the device.
Warning!
If the conveyor belt moves laterally, the Flex-Lifter may tilt and fall.
Before starting work on the unit, make sure that the conveyor belt is disconnected from the power
supply, and protected against reconnection.
Before starting work on the unit, make sure that the conveyor belt cannot move laterally. If the
bands are tilted, the belt needs to be effectively blocked by clamping.