Flexco FL-L-EC, Инструкция по установке, эксплуатации и обслуживанию

Страница: 38 / 56

38
Flex-Lifter Belt Lifters
Section 5 – Operation And Handling
5.1 Safety Regulations
Warning!
The device may tilt, slip or fall during operation.
The raised conveyor belt may be jerky and move downward.
Make sure that the conveyor belt is safely disconnected from the mains and has been locked against
unauthorized activation.
Make sure that the conveyor belt cannot move laterally when it is out of service. Block the belt, if
necessary.
During set-up, ensure that the device is on a flat bearing surface, and has a secure grip on the frame of
the conveyor belt.
The width of the extendable foot sections must be properly adjusted.
The blade pins must all be reinstated and secured with split pins.
The base on which the Flex-Lifter stands, must be designed for the expected maximum load.
Warning!
If the conveyor belt is too heavily loaded on the Flex-Lifter, the Flex-Lifter can buckle or break. Please
note the maximum permissible lifting capacity.
If in doubt, you must relieve the belt by removing the conveying material and, if necessary, reducing the
belt tension.
Limit the torque of the ratchet or the power wrench whilst raising the Flex-Lifter.
Ensure that the safety distance from the head and end rollers of the conveyor belt is at least 6m.
Warning!
The device has been built for “single-person operation” (raising and lowering). Risk of injury caused by
other people using the device.
Ensure that during operation, only one person is using the device.
Exception: As a general rule, two people are required to set up and dismantle the conveyor belt.
Warning!
Risk of crushing or shearing by the linkage of the Flex-Lifter when raising and lowering.
Keep your hands and limbs away from the hazardous area when raising and lowering the conveyor belt.