O P T I O N A L
Safety Rails
All Flexabed Hi-Low models come factory equipped with a plate mounting system
at the head and foot sections of the bed to facilitate a quick and sturdy installation
of your Flexabed safety rails. The only tool needed to complete a safety rail installa-
tion is a 9/16” wrench.
1. Raise the head section of the bed to the most upright position using your hand
control. If installing safety rails at the foot section, then also raise the foot sec-
tion to the most upright position.
On twin beds, failing to raise the head and/
or foot sections of the bed before installing safety rails can cause serious
damage to your bed and damages caused by improper safety rail installa-
tion is not covered under warranty!
2. After raising the head section to 100%, locate the 2 bolts and nuts on the under-
side of the foundation approximately 1” from the edge of the bed (Fig. 11).
3. Remove the nuts from the bolts using a 9/16th wrench (Fig. 12).
C O N T I N U E D O N N E X T P A G E .
FIG. 11
FIG. 12
7
