12
B L U E T O O T H
Connectivy
Your Flexabed can be controlled with any compatible Bluetooth
enabled Android or iPhone device. To pair your device to your
Flexabed, perform the following procedures:
1. Activate the Bluetooth pairing mode on your Flexabed control
box by either of these two methods:
• Unplug the bed from your electrical receptacle for at least
60 seconds and then plug the bed back in.
• Locate the quarter-sized pairing button on the side of your
control box located underneath the bed (Fig. 6 on Page 4).
Press the button two times in quick succession.
2. If you have performed Step 1 correctly, the pairing button on
the side of your control box will be illuminated in a blue color.
The button will remain illuminated for 60 seconds. After 60
seconds, the button will flash for an additional 60 seconds. The
control box is in Bluetooth pairing mode only during the 60
seconds when the button is flashing.
3. While your bed is in Bluetooth pairing mode (button flashing
for 60 seconds), activate Bluetooth detection on your compati-
ble device and perform a scan for available devices. You should
see a device named “OKIN-Receiver.” Select the device named
“OKIN-Receiver” and pair it to your device.
S Y N C I N G
Your Hand Control
(wireless remote only)
If your bed is equipped with a wireless remote, the remote is
automatically synced to your bed at the factory during the manu-
facturing process. In the event that you order a new replacement
remote or a new control box in the future, you will have to sync the
wireless remote to your control box. To sync a wireless remote to
your control box:
1. Press the quarter-sized pairing button on your control box two
times in quick succession until the blue LED light on the pairing
button is illuminated.
2. Once the blue LED light is illuminated, you have 60 seconds to
pair the remote to the control box. If the LED light starts blink-
ing, you will have to restart the process.
3. While the blue LED light is illuminated, press the head up
button and the flat button at the same time. If the pairing is
performed correctly, the pairing button will flash two times
and will make a “beep” sound indicating that the remote and
control box have successfully paired.
