S T E P O N E
Remove any items attached to
the bed for shipping purposes.
First remove the hardware carton that is stapled to the underside of the bed
(Fig. 1). The hardware carton contains your hand control, power supply, casters
and/or leg caps, and bed literature. Next, remove the wooden leg pads that are
inserted in to each bed leg. Finally, if you ordered safety rails, remove the rails
from the frame. Each safety rail is zip tied to the bed frame.
S T E P T W O
Install your casters/leg caps into each leg.
To install casters, insert the caster into the threaded insert on the bed leg. Next,
using your fingers, thread the caster into the bed leg by rotating the hex nut
(Fig. 2a). Once you can no longer use your finger to tighten the caster, use a ½”
wrench to finish tightening the caster in to the bed leg (Fig. 2b). Once the bed is
turned upright, you can lock each caster by depressing the locking lever on each
caster (Fig. 2c). It may be easiest to lock the caster using your foot.
If you ordered leg caps instead of casters, insert each leg cap into the threaded
insert on each bed leg. Hand tighten the leg cap in the bed leg until it is flush with
the hex nut (Fig. 3). You can adjust each leg cap as needed to level the bed.
FIG. 1
FIG. 3
FIG. 2A
FIG. 2B
FIG. 2C
HARDWARE
CARTON
SIDE RAILS
SIDE RAILS
3
