16
FIG. 19
C O N T R O L B O X C O N N E C T I O N S
The control box is the “brain” of your Flexabed which allows the hand control
to communicate with all of the motors on your bed. There are four ports on the
control box. If you have checked all connections on the power supply and the head
motor splitter cable, the next step is to check all connections on your control box
and make sure that the plugs are securely connected to the control box (Fig. 19).
Port 1 (Hi-Low Motor) – This port is where your hi-low motor plugs in.
Port 2 (Unused) – This port is not used. Nothing should be plugged into port #2.
Port 3 (Massage) – This port is the massage system port. Your bed may or may
not be equipped with a massage system depending on if you ordered it or not
when you purchased your bed. If your bed is equipped with a massage system, the
massage 2-way splitter cable should be plugged in to this port. The head and foot
massage motors plug in to the 2-way splitter cable and the cable with the red label
plugs in to the foot massage motor. If your bed is not equipped with a massage
system, then nothing should be plugged in to this port.
Port 4 (Accessory & Wired Remote Port) – This port is used for optional accessory
items such as an LED underbed lighting system and/or a wired hand control. It is
possible that nothing is plugged in to this port if you have a wireless hand control
and did not order an underbed lighting system. The only time that something
must
be plugged in to this port is if you have a wired hand control, and in that case the
hand control must be plugged in to this port at all times.
1
2
3
4
