Lit. No. 49591, Rev. 05
8
July 15, 2020
27775, 28069, 57000, 57000‑1, 57000‑3
HEADLAMPS
Headlamps, hardware, and instructions are found in
the headlamp box.
1.
Install the vehicle wiring according to the
instructions provided.
2.
With the driver‑ and passenger‑ side headlamps
on the correct sides, set each headlamp and
swivel into place on the headgear light bar.
3.
Secure the headlamps with the correct hardware
for the application as shown below. Inner and
outer posts require different hardware. On LED
headlamps, a rubber washer must be installed
under the slotted holes. Hand tighten fasteners.
4.
Connect the headlamp wires to the headlamps.
5.
Aim the headlamps according to the Snowplow
Headlamp Beam Aiming Instructions
(Lit. No. 27769). For LED headlamps,
tighten the fasteners to 22 ft‑lb (30 N·m). For
halogen headlamps, tighten the fasteners to
50 ft‑lb (68 N·m).
WARNING
Your vehicle must be equipped with snowplow
headlamps and directional lights.
Halogen Headlamps
LED Headlamps
Headlamp
Swivel
Headgear
Light Bar
1/2" Flat
Washers
1/2" Lock
Washers
1/2" Hex Nuts
Slotted
Hole
1/2" Rubber
Washer
6.
Secure the snowplow harnesses and wires to the
headgear with cable ties as shown.
Cable
Ties
Cable
Tie
Snowplow
Lighting
Harness
