Fischer Panda Panda PMS-HD 12-4KU, Руководство пользователя

Страница: 13 / 148

13
Safety Precautions
The electrical installations may only be carried out by trained and
qualified personnel!
Safety Instructions concerning operating the generator
• The generator must not be taken into use with the cover removed.
• If the generator is being installed without a sound insulation capsule, then make sure, that all rotating parts (belt-
pulley, belts etc) are covered and protected so that there is no danger to life and body!
• If a sound insulation covering will be produced at the place of installation, then well-placed signs must show that
the generator can only be switched on with a closed capsule.
• All servicing-, maintenance or repair work may only carried out, when the motor is not running.
• There is full current in the AC control box when the generator is running. It must therefore be ensured that the con-
trol box is closed and cannot be touched when the generator is running.
• Do not work in an ambient, where there are explosives. Working on an electrical system in an ambient where there
are flammable gases is dangerous.
• Electrical voltages above 48 volts (battery chargers greater than 36 volts) are always dangerous to life). The rules
of the respective regional authority must be adhered to. Only an electrician may carry out installation of the elec-
trical connections for safety reasons.
Ground Wire:
The generator, is "earthed" as series (centre and ground are connected together in the generator terminal box by a
bridge). This is an initial ground fuse, which offers protection, as long as no other measures are installed. Above all,
it is conceived for the delivery and possible test run.
This "neutralisation" (Protective Earthing Neutral - PEN) is only effective, if all parts of the electrical system are com-
monly "earthed" to a common potential. The bridges can be removed, if this is necessary for technical reasons and
another protective system has been setup.
Safety Instructions concerning working on the generator
The battery must always be disconnected, if work on the generator or electrical system is to be carried out, so that
the generator cannot be unintentionally started. It is not allowed to disconnect the battery during operation!
After the generator has been stopped, the battery can be disconnected!
Switch off all load when working on the generator
All load must be disconnected, in order to avoid damages to the devices. In addition the semi conductors in the AC
control box must be disconnected in order to avoid the boat capacitors being activated. The minus pole of the battery
ought to be removed.