Fischer Panda Panda PMS-HD 12-4KU, Руководство пользователя

Страница: 107 / 148

Tables
Panda PMS 8.000 NE - 42 NE Manual - Chapter E: Tables Page 107
MOTOR DOES ACHIEVE ENOUGH SPEED DURING STARTING PROCESS
Cause Solution
Starter battery voltage insufficient. Check battery.
Damaged bearing(s) piston (seized). Repairs need to be carried out by Kubota-Service.
(refer to Kubota motor-manual)
Cooling water in combustion chamber. 1. Turn generator "OFF" at control panel.
2. Remove the glow plug (see Kubota-manual).
3. Rotate the motor by hand carefully.
4. Check if there is water in the oil and change both oil
and filter if necessary.
5. Determine cause for excess water in the combu-
stion chamber. The excess water can be caused by
a defective air vent in the cooling water system,
which should be checked and cleaned, or replaced
if faulty.
MOTOR SPEED DROPS
Cause Solution
Lack of fuel Check fuel supply system:
- fuel filter, renew if necessary
- check fuel pump
- check fuel lines (bleed if necessary)
Lack of intake air. Check air intake paths.
Check and clean air filter (and intake muffler if instal-
led).
Generator overloaded by too many load. Reduce the electrical load (switch off load).
Generator overloaded by over-energizing. Check that the proper capacitor type is installed and
that they are connected correctly.
Defective generator (windings, bearings, or other). Generator must be sent to manufacturer for repair of
damaged bearings or winding.
Damaged engine. Repair of bearing damage, etc., by Kubota-Service.
MOTOR RUNS IN OFF POSITION
Cause Solution
Fuel inlet solenoid valve or throttle shut solenoid is not
switching off. Check wire connections to solenoid. Check valve
functions as in the "Fuel Solenoid Valve" or in the trottle
shut off solenoid sections. Replace if necessary.